ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 348)

ZyWALL 10~100 Series Internet Security Gateway
24-6 LAN Setup
Table 24-3 IP Alias Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
Incoming
Protocol Filters Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the ZyWALL. 1
Outgoing
Protocol Filters Enter the filter set(s) you wish to apply to the outgoing traffic
between this node and the ZyWALL. 2
When you have completed this menu, press [ENTER] at the prompt [Press ENTER to Confirm…] to save
your configuration, or press [ESC] at any time to cancel.
24.5 Wireless LAN Setup
Use menu 3.5 to set up your ZyWALL as the wireless access point.
See the Web Configurator User’s Guide for instructions on WEP and configuring the MAC address filter.
If you are configuring the ZyWALL from a computer connected to the wireless LAN
and you change the ZyWALL’s ESSID or WEP settings, you will lose your wireless
connection when you press [ENTER] to confirm. You must then change the
wireless settings of your computer to match the ZyWALL’s new settings.
From the main menu, enter 3 to open Menu 3 – LAN Setup to configure the Wireless LAN setup. To edit
the wireless LAN configuration, enter 5 to open Menu 3.5 – Wireless LAN Setup as shown next.
Figure 24-6 Menu 3.5 – Wireless LAN Setup
Menu 3.5 - Wireless LAN Setup
Enable Wireless LAN= No
ESSID= Wireless
Hide ESSID= No
Channel ID= CH01 2412MHz
RTS Threshold= 2432
Frag. Threshold= 2432
WEP= Disable
Default Key= N/A
Key1= N/A
Key2= N/A
Key3= N/A
Key4= N/A
Edit MAC Address Filter= No