ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 512)

ZyWALL 10~100 Series Internet Security Gateway
B Troubleshooting
Problems with the LAN Interface
Chart 2 Troubleshooting the LAN Interface
PROBLEM CORRECTIVE ACTION
Check your Ethernet cable type and connections. Refer to the Quick Start Guide or
Compact Guide for LAN connection instructions. Cannot access
the ZyWALL
from the LAN.
Make sure the computer’s Ethernet adapter is installed and functioning properly.
Check the 10M/100M LAN LEDs on the front panel. One of these LEDs should be on. If
they are both off, check the cables between your ZyWALL and hub or the station. Cannot ping
any computer
on the LAN.
Verify that the IP address and the subnet mask of the ZyWALL and the computers are
on the same subnet.
Problems with the DMZ Interface
The DMZ interface is not available on all models.
Chart 3 Troubleshooting the DMZ Interface
PROBLEM CORRECTIVE ACTION
Check your Ethernet cable type and connections. Refer to the Quick Start Guide or
Compact Guide for DMZ connection instructions.
Make sure the Ethernet adapters on the LAN computer and the DMZ server are installed
and functioning properly.
Verify that the IP address of the DMZ port and the LAN port are on separate subnets.
Cannot
access
servers on the
DMZ from the
LAN.
Make sure that NAT is configured for your DMZ servers.
Check the 10M/100M DMZ LEDs on the front panel. One of these LEDs should be on. If
they are both off, check the cables between your ZyWALL and hub or the station. Cannot ping
any computer
on the DMZ.
Verify that the IP address and the subnet mask of the ZyWALL and the servers are on
the same subnet.