ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 240)

ZyWALL 10~100 Series Internet Security Gateway
16-2 Remote Management Screens
3. The IP address in the Secured Client IP field does not match the client IP address. If it does not
match, the ZyWALL will disconnect the session immediately.
4. There is an SMT console session running.
5. There is already another remote management session of the same type (web, FTP or Telnet) running.
You may only have one remote management session of the same type running at one time.
6. There is a web remote management session running with a Telnet session. A Telnet session will be
disconnected if you begin a web session; it will not begin if there already is a web session.
16.1.2 Remote Management and NAT
When NAT is enabled:
Use the ZyWALL’s WAN IP address when configuring from the WAN.
Use the ZyWALL’s LAN IP address when configuring from the LAN.
16.1.3 System Timeout
There is a system timeout of five minutes (three hundred seconds) for either the console port or
telnet/web/FTP connections. Your ZyWALL automatically logs you out if you do nothing in this timeout
period, except when it is continuously updating the status in menu 24.1 or when sys stdio has been
changed on the command line.
16.2 Telnet
You can configure your ZyWALL for remote Telnet access as shown next.