ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 383)

ZyWALL 10~100 Series Internet Security Gateway
NAT 29-3
Figure 29-2 Menu 11.3: Applying NAT to the Remote Node
The following table describes the fields in this screen.
Table 29-1 Applying NAT in Menus 4 & 11.3
FIELD DESCRIPTION OPTIONS
When you select this option the SMT will use Address Mapping Set 1
(menu 15.1 - see section 29.2.1 for further discussion). You can
configure any of the mapping types described in the Web Configurator
User’s Guide. Choose Full Feature if you have multiple public WAN IP
addresses for your ZyWALL.
When you select Full Feature you must configure at least one
address mapping set!
Full Feature
NAT is disabled when you select this option. None
Network
Address
Translation
When you select this option the SMT will use Address Mapping Set
255 (menu 15.1 - see section 29.2.1). Choose SUA Only if you have
just one public WAN IP address for your ZyWALL. SUA Only
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= Full Feature
Metric= N/A
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.