ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 347)

ZyWALL 10~100 Series Internet Security Gateway
LAN Setup 24-5
24.4.1 IP Alias Setup
You must use menu 3.2 to configure the first network. Move the cursor to the Edit IP Alias field, press
[SPACE BAR] to choose Yes and press [ENTER] to configure the second and third network.
Press [ENTER] to open Menu 3.2.1 - IP Alias Setup, as shown next.
Figure 24-5 Menu 3.2.1: IP Alias Setup
Use the instructions in the following table to configure IP Alias parameters.
Table 24-3 IP Alias Setup Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Alias Choose Yes to configure the LAN network for the ZyWALL. Yes
IP Address Enter the IP address of your ZyWALL in dotted decimal notation. 192.168.2.1
IP Subnet Mask Your ZyWALL will automatically calculate the subnet mask based
on the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the ZyWALL. 255.255.255.0
RIP Direction Press [SPACE BAR] and then [ENTER] to select the RIP
direction. Options are
Both, In Only, Out Only or None. None
Version Press [SPACE BAR] and then [ENTER] to select the RIP version.
Options are
RIP-1, RIP-2B or RIP-2M. RIP-1
Menu 3.2.1 - IP Alias Setup
IP Alias 1= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
IP Alias 2= No
IP Address= N/A
IP Subnet Mask= N/A
RIP Direction= N/A
Version= N/A
Incoming protocol filters= N/A
Outgoing protocol filters= N/A
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.