ZyXEL Communications ZyXEL ZyAIR 100 - Manual (Page 378)

ZyWALL 10~100 Series Internet Security Gateway
28-2 IP Static Route Setup
Figure 28-2 Menu 12. 1: Edit IP Static Route
`The following table describes the IP Static Route Menu fields.
Table 28-1 IP Static Route Menu Fields
FIELD DESCRIPTION
Route # This is the index number of the static route that you chose in menu 12.
Route Name Enter a descriptive name for this route. This is for identification purposes only.
Active This field allows you to activate/deactivate this static route.
Destination IP
Address This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet
Mask Enter the IP subnet mask for this destination.
Gateway IP
Address Enter the IP address of the gateway. The gateway is an immediate neighbor of your
ZyWALL that will forward the packet to the destination. On the LAN, the gateway
must be a router on the same segment as your ZyWALL; over the WAN, the gateway
must be the IP address of one of the remote nodes.
Metric Enter a number from 1 to 15 to set this route’s priority among the ZyWALL’s routes
(see the Metric section in the WAN and Dial Backup Setup chapter). The smaller the
number, the higher priority the route has.
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to CONFIRM or ESC to CANCEL: