Freescale Semiconductor Microcontrollers - Manual (Page 838)

Debugger Engine Commands
Debugger Commands
838 Microcontrollers Debugger Manual
ZOOM
In the Data component, the ZOOM command is used to display the member fields of
structures by ‘diving’ into the structure. In contrast to the
UNFOLD command, where
member fields are not expanded in place. The display of the member fields replaces the
previous view. The ZOOM out command is used to return to the nesting level indicated
by the given identifier.
NOTE Addresses are not needed to zoom out. Simply type “ZOOM out”.
NOTE This command is relevant when “C-source” debugging.
Usage
ZOOM address in|out
Where address is the address of the structure or pointer variable to zoom in or
zoom out, respectively.
Components
Data component.
Example:
in>ZOOM 0x1FE0 in
The variable structure located at address 0x1FE0 is zoomed in.
in>zoom &_startupData
zooms in the _startupData structure (&_startupData is the address of the
_startupData structure).