Freescale Semiconductor Microcontrollers - Manual (Page 467)

467 Microcontrollers Debugger Manual
19
HCS08 P&E Multilink/
Cyclone Pro Connection
The HCS08 P&E Multilink/Cyclone Pro Connection setting permits a connection to
Multilink/Cyclone Pro devices. HCS08 P&E Multilink/Cyclone Pro connection mode
allows the user to debug code, as the firmware is fully resident in the Flash of the
microprocessor. The operation of all modules fully reflects the actual operation of the on-
board resources.
Connection Procedure
To select the P&E Multilink/Cyclone Pro as your debugger connection:
1. Choose the P&E Multilink/Cyclone Pro option from the set connection dialog box as
shown in Figure 19.1 .
2. Click the OK button.
Figure 19.1 Set Connections Dialog Box
3. Choose the P&E device that you are using from the Connection drop-down menu and
click on Refresh. See Figure 19.2 and Figure 19.3 .