Freescale Semiconductor Microcontrollers - Manual (Page 553)

553 Microcontrollers Debugger Manual
25
RS08 P&E Multilink/Cyclone
Pro Connection
The RS08 P&E Multilink/Cyclone Pro Connection setting permits a connection to
Multilink/Cyclone Pro devices. RS08 P&E Multilink/Cyclone Pro connection mode
allows the user to debug code, as the firmware is fully resident in the FLASH of the
microprocessor. The operation of all modules fully reflects the actual operation of the on-
board resources.
Connection Procedure
To select the P&E Multilink/Cyclone Pro as your debugger connection:
1. Choose the P&E Multilink/Cyclone Pro option from the Set Connection dialog box as
shown in Figure 25.1 .
2. Click the OK button.
Figure 25.1 Set Connection Dialog Box
3. Choose the P&E device that you are using from the Interface list menu and click on
Refresh List. See Figure 25.2 and Figure 25.3 .