Freescale Semiconductor Microcontrollers - Manual (Page 101)

Debugger Components
General Debugger Components
101 Microcontrollers Debugger Manual
Drag Out
Table 3.22 describes the drag actions possible from the Memory component.
Show
Watchpoints When selected, brings up the Controlpoints Configuration Window -
Watchpoints Tab. This is the interface through which watchpoints
are controlled. (See
Control Points chapter).
Set Markpoint Appears in the context menu only if no watchpoint is set or disabled
on the selected memory range. When selected, sets a Read/Write
watchpoint at this memory area.
Show
Markpoints When selected, brings up the Controlpoints Configuration Window -
Markpoints Tab. This is the interface through which markpoints are
controlled. (See
Control Points chapter).
Show Location Forces all opened windows to display information about the
selected memory area.
Word Size, etc. The submenus are explained in Table 3.16
Table 3.22 Memory Component Drag Possibilities
Destination
Component Window Action
Assembly Displays disassembled instructions starting at the first
address selected. The instructions corresponding to the
selected memory area are highlighted in the Assembly
component.
Command Line Appends the selected memory range to the Command Line
window.
Register Loads the destination register with the start address of the
selected memory block.
Source Displays high level language source code starting at the first
address selected. Instructions corresponding to the
selected memory area are grayed in the source component.
Table 3.21 Memory Context Menu Description ( continued)
Menu Entry Description