Freescale Semiconductor Microcontrollers - Manual (Page 218)

Debugger DDE Capabilities
218 Microcontrollers Debugger Manual
3. Push the Connect button of the DDEClient. The following message appears in
DDECLient: Connected to HI-WAVE|Command.
4. In the Exec field of DDECLient type a Debugger command, for example open
recorder and click the Exec button. The command is executed by way of DDE and
a new recorder component appears in the Debugger.
NOTE You can disconnect the DDE in the Debugger. The Debugger can be started
without DDE (this is saved in the project file). To view the current state, open a
command line component and type the following command: DDEPROTOCOL
STATUS
. The state must be: DDEPROTOCOL ON to ensure the DDE works
properly.