Freescale Semiconductor Microcontrollers - Manual (Page 267)

HC08 Full Chip Simulation
Configuration Procedure
267 Microcontrollers Debugger Manual
INPUT Command
The INPUT command sets the simulated inputs to port . The CPU reads this input
value when port is set as an input port.
Syntax
>INPUT
Where:
is the letter representing corresponding port
Eight-bit simulated value for port
Example
>INPUTA AA
Simulate the input AA on port A.
INPUTS Command
In Full Chip Simulation and CPU-Only Simulation mode, the INPUTS command opens
the Simulated Port Inputs dialog box shown in
Figure 11.17 below. The user may then use
this box to specify the input states of port pins and IRQ.
Figure 11.17 Simulated Port Inputs Dialog Box
When using In-Circuit Simulation mode, the INPUTS command shows the simulated
input values to any applicable port.
Syntax
>INPUTS