Freescale Semiconductor Microcontrollers - Manual (Page 570)

SofTec RS08 Connection
First Steps From Within an Existing Project
570 Microcontrollers Debugger Manual
First Steps From Within an Existing Project
To take the first steps toward debugging with the CodeWarrior IDE and setting the SofTec
RS08 connection from within an existing debugging project:
1. Run the CodeWarrior IDE with the shortcut created in the program group.
2. Open the project.
3. Choose the menu Project > Debug to start the debugger.
4. Choose in the debugger menu Component > Set Connection to select another target
interface in the Set Connection dialog box.
5. Select RS08 as the Processor then SofTec RS08 as the connection.
Figure 27.3 Set Connection Dialog Box - SofTec RS08 Selection
6. Press the OK button - MCU Configuration dialog box opens.
7. In the MCU Configuration dialog box, choose the correct target processor.