Freescale Semiconductor Microcontrollers - Manual (Page 402)

HC08 FSICEBASE Emulator
FSICEBASE Overview
402 Microcontrollers Debugger Manual
System Requirements
The FSICEBASE system requires a host computer with the following minimum
specifications:
• Processor: 200 MHz Pentium® II processor or AMD-K6® class processor
• Operating System: Microsoft® Windows® 2000, Windows® XP, or Windows
Vista™
• RAM: 128 MB
• Hard drive space: Compact software installation: 232 MB
Full software installation: 344 MB
• USB port or Ethernet port to connect host computer to the FSICEBASE
System Features
The Freescale In-Circuit Emulator Base (FSICEBASE) is a full-featured development
system that provides in-circuit emulation. Features include:
• Real-time, non-intrusive, in-circuit emulation
• Real-time bus state analysis
• Meets ECC92 European electromagnetic compatibility standards
• Allows you to set four complex data or instruction breakpoints; a breakpoint can be
qualified by an address, an address range, data, or externally connected logic clips.
• Up to 128k real-time variables (any ROM or RAM memory area)
• Up to 128 Kilobytes of emulation memory to accommodate the largest available
ROM size of current HC08 MCU
• Unlimited hardware instruction breakpoints over the 64-K memory map
• Built-in bus state analyzer:
– 1.33Mb x 96 real-time trace buffer
– Four hardware triggers to control real-time bus analysis and provide breakpoints
– Nine triggering modes
– Display of real-time trace data as raw data, disassembled instructions, raw data
and disassembled instructions, or assembly-language source code
– As many as 1.33M pre- or post-trigger points
– Trace buffer can be filled while single-stepping through user software
– 32-bit time tag
– Custom clock from 4100Hz to 40MHz in 5kHz steps, permitting wide time
variance between analyzer events