Freescale Semiconductor Microcontrollers - Manual (Page 766)

Debugger Engine Commands
Debugger Commands
766 Microcontrollers Debugger Manual
CLOSE
The CLOSE command is used to close a component.
Component names are: Assembly, Command, Coverage, Data, Inspect, IO_Led, Led,
Memory, Module, Phone, Procedure, Profiler, Recorder, Register, SoftTrace, Source,
Stimulation.
Usage
CLOSE component | *
where * means “all components”.
Components
Debugger engine.
Example:
in>CLOSE Memory
The Memory component window is closed (unloaded).
COPYMEM
The COPYMEM command is used to copy a memory range to a destination range
defined by the beginning address. This command works on defined memory only. The
source range and destination range are tested to ensure they are not overlayed.
Usage
COPYMEM dest-address
Components
Memory.
Example:
in>copymem 0x3FC2A0..0x3FC2B0 0x3FC300
The memory from 0x3FC2A0 to 0X3FC2B0 is copied to the memory at 0x3FC300
to 0x3FC310. This Memory range appears in red in the Memory Component.