Freescale Semiconductor Microcontrollers - Manual (Page 728)

Debugging Memory Map
DMM Commands
728 Microcontrollers Debugger Manual
DMM OPENGUI command
Syntax
DMM OPENGUI [mcuid]
with , a part/device MCUID value in range $0-$FFFF.
Purpose
Opens the DMM Graphical User Interface. Note that the MCUID parameter is not
mandatory.
DMM SETAHEADREADSIZE command
Syntax
DMM SEATAHEADREADSIZE
when halted>
running>
with:
: amount of bytes to read ahead of exact start of
read block address, when the hardware is halted.
: amount of bytes to read after the exact block of
read addresses, when the hardware is halted.
: amount of bytes to read ahead of exact start
of read block address, when the hardware is running.
: amount of bytes to read after the exact block
of read addresses, when the hardware is running.
Purpose
Special debugger memory cache tuning in case of slow connection with hardware.