Freescale Semiconductor Microcontrollers - Manual (Page 266)

HC08 Full Chip Simulation
Configuration Procedure
266 Microcontrollers Debugger Manual
Figure 11.15 Simulated Port Inputs Dialog Box
Using the Simulated Port Inputs dialog box, the input value to any I/O port can be
reconfigured. The INPUTS command can be used to reconfigure the output values on any
relevant I/O port. The manipulation of I/O port pins can be observed in the Memory
Window.
Figure 11.16 Memory Component Window
Note that if the regular I/O pins are multiplexed to be used by a different MCU Module,
they might not be available for general I/O functionality. For more information on how to
properly configure I/O pins, refer to the Freescale user manual corresponding to the
microprocessor that you are using.
Input/Output Ports Commands
Use the following commands for general IO port manipulation.