Xerox VersaLink C500/DN Color Laser Printer - Manual (Page 38)

C Coonnffiigguurriinngg tthhee PPrriim maarryy N Neettw woorrkk aatt tthhee C Coonnttrrooll PPaanneell
You can set the primary network connection type at the device control panel.
Note:
• A Primary Network setup is required only if the optional Wi-Fi network connection kit is
installed and enabled.
• By default, without a Wi-Fi network connection, the primary network is set to Ethernet.
When the kit is installed and enabled, the device acquires two network connections. One
network connection is primary, and the other network connection is secondary.
• The following features are available only over the primary network connection:
– IPsec
– SMTP
– SNTP
– WSD scan
– Scan to SFTP, Scan to SMB, Scan to Email
– LDAP
– UPnP discovery
– ThinPrint
– EIP Web Service
• If you remove the Wi-Fi network connection module, the primary network connection is set
to Ethernet.
To configure the Primary Network at the control panel:
1. At the printer control panel, press the Home button.
2. Log in as administrator. For details, refer to Accessing the Control Panel as a System
Administrator .
3. Touch Device → Connectivity → Primary Network .
4. Select the appropriate network connection type for the device.
5. To apply the changes and restart the device, at the prompt, touch Restart Now .
38 Xerox ® VersaLink ® Series Multifunction and Single Function Printers
System Administrator Guide
Network Connectivity