Xerox VersaLink C500/DN Color Laser Printer - Manual (Page 31)

1. Click DNS .
2. For Domain Name, type the name of the domain for the printer.
3. For Connection Timeout, type the number of seconds that the printer waits to receive a response
from the DNS server.
4. To enable DHCP to assign the IP address, in the IPv4 DNS Servers area, for Use DHCP to Assign
Address, select the toggle button.
5. If you did not enable DHCP, type the IP addresses for the primary and alternate servers.
6. To enable DHCPv6-lite to assign the IP address, in the IPv6 DNS Servers area, for Use DHCPv6-lite
to Assign Address, select the toggle button.
7. If you did not enable DHCPv6-lite, type the IP addresses for the primary and alternate servers.
8. To generate a domain search list automatically, in the DNS Search Domains area, for Generate
Domain Search List Automatically, select the toggle button.
9. If you did not enable DHCP, type the IP addresses for the primary and alternate servers.
10. Click OK .
To configure the security settings:
1. In the Security Settings area, click Encryption , then select the appropriate security option. For the
mode of encryption that you selected, configure the security settings.
2. For WEP:
• To set a transmit key to active, click Transmit Key , then select an option.
• For each Transmit Key, type values into the corresponding fields.
3. For WPA2 Personal and Mixed Mode Personal, in the Passcode and Retype Passcode fields, type
the network passcode.
4. For WPA2 Enterprise and Mixed Mode Enterprise:
• Click Authentication Method , then select an option.
• If your system uses root certificates, click Root Certificate , then select an option.
• Type values for EAP Identity, Login Name, and Password.
5. Click OK .
To finish the Wi-Fi setup:
1. To activate your changes, at the prompt, click Restart Now .
2. Disconnect the Ethernet cable from the printer.
3. After the printer restarts, wait 2 minutes, then print a Configuration Report.
Note: The Configuration Report contains the IP address for the printer. For details, refer to
Printing the Configuration Report .
If the printer does not successfully connect with the wireless network, check your network information
and repeat this procedure.
Xerox ® VersaLink ® Series Multifunction and Single Function Printers
System Administrator Guide
31
Initial Setup