Visara LINCS Central Control - Manual (Page 66)

60
LINCS Central Control
707024-002
SNA Concentrator FAD *
This FAD is required on the 9300 model if SNA Concentrator is enabled on the Product
Definition Panel.
Access Server FAD *
This FAD is required on the 9300 model if Access Server is enabled on the Product
Definition Panel.
APPN Network Node FAD *
This FAD is required if APPN is configured.
TN3270 Server (Now part of ‘TN3270/IPX SNA Clients’)
This FAD is required if more than 16 TN3270 clients are configured, but has been superseded
by the TN3270/IPX SNA Clients FAD. Any combination of these FADs may be activated up
to a maximum of 1024 TN3270 Users. The currently available FADs are:
• 16 Connections
• 64 Connections
• 128 Connections
• 256 Connections
Frame Relay FAD *
This FAD enables Frame Relay on all HSC lines.
X.25 Gateway *
The gateway support for X.25 will allow hosts on the upstream side to access devices on the
downstream side via LLC, TCP/IP, Token Ring, etc. Also gateway support for X.25 on the
downstream side will allow those devices tied on the X.25 network to access hosts on the
upstream side via LLC, TCP/IP, Token Ring, etc.
Extended ESCON CUs
This FAD permits additional CUs to be configured beyond what is supported by the basic
LINCS software. It is required if you wish to run more than 4 CUs on the SCON-22L, more
than one CU per eSCON card on the 1174-25S, and is also used with the SCON-25L when
more than one ESCON card is installed. This FAD comes in 3 different increments, and may
be added cumulatively to allow the maximum number of CUs supported by the specific models.
The currently available FADs are:
· 1 Extended CU
· 4 Extended CUs
· 16 Extended CUs
Incoming/Outgoing Telnet
This FAD allows support for more than 32 Incoming or Outgoing Telnet connections. Installing
this FAD permits up to the maximum Telnet connections supported by the specific model.
Note that additional Ethernet (or Token Ring) cards may have to be added to support the
maximum number of sessions allowed on a particular model.
TN3270/IPX SNA Clients
This FAD is required if more than 32 IPX SNA or TN3270 clients are configured. When
installed, this FAD will allow as many clients as the platform supports to be configured.