Visara LINCS Central Control - Manual (Page 101)

95
Chapter 11. Device Menu
707024-002
PF1 returns you to the Supervisor Functions Menu.
PF3 returns you to the LPD Queue Management panel.
PF8 and PF7 scrolls the screen, if there are more jobs than will fit on one screen.
PF9 refreshes the screen.
PF10 processes job deletion. Place a “d” in front of the jobs you wish to delete, as shown above.
LPD Printer Management
This utility allows you to manage LPD print jobs that are queued to a LAN printer.
LPD Printer Management LINCS C8.2 Central Control
CMD Port Queue Name Status Size Kbytes
— ———— ———————— ————— —————
ETH1.000 1330 Printing 1
PF: 1-Menu 7-Back 8-Forw 9-Refresh 10-Process
CMD
The CMD (Command) column allows you to issue commands to a queued print job. Command
instructions that can be used are: D - Delete the print job.
Port and Queue Name
This identifies the virtual port on the LAN card that the print job was directed to. Each virtual
port is assigned to a specific IP address on the Network Device Definition panel of
configuration. The Queue name is configured on the same panel as the LAN printer’s IP
address and represents the LPD Queue name that is defined at the print server that this print
job is being directed.
Status
This field identifies what state the queued up print is in. Possible states are:
• Printing
• Idle
• Holding
Size Kbytes
The size field indicates how large the queued up print job is. Values are rounded up to the next
1 KB value.