Visara LINCS Central Control - Manual (Page 65)

59
Chapter 6. Windowing Setup
707024-002
Incoming LANSYS *
This FAD is required if any Incoming LANSYS connections are configured on any LAN
Line. Five different FADs are sold:
8, 16, 32, 64 and 128 connections
They may be used in any combination to support up to 256 LANSYS connections.
Outgoing TELNET Connections (Now part of ‘Incoming/Outgoing Telnet’)
This FAD is required if more than 2 Outgoing TELNET Connections (from LINCS to a
TELNET Host) , or any LAN Print Server Connections (TCP and LPD) are configured, but
has been superseded by the Incoming/Outgoing Telnet FAD. Four different FADs are sold:
16, 32, 64, and 128 connections
They may be used in any combination to support up to 256 outgoing TELNET Connections.
Outgoing LAT Connections *
This FAD is required if any Outgoing LAT Connections are configured, and at least one
Device Profile allows access to LAT Hosts. Two FADs are sold to allow devices access to
Outgoing LAT Connections:
• Port LAT Terminal Server allows up to 16 ports
• Extended LAT Terminal Server combined with the 16 Port FAD, enables LAT Terminal
Server sessions on up to 256 ports
Generation C Support FAD *
The Generation C FAD is required to IML with LINCS Generation C software. To configure
and enable the FAD, IML with default data objects (by pressing Config when the controller is
at state 500).
Extended Device Support *
This FAD is only required for 1174 models, and allows the number of attached devices to
exceed 64.
TCP/IP SNA Encapsulation Support FAD *
This feature is required to communicate via SNA over TCP/IP.
Incoming LAT *
This FAD is required if any LAT displays are configured on a Network Device Definition panel.
Incoming TELNET (Now part of ‘Incoming/Outgoing Telnet’)
This FAD is required if any TELNET devices are configured on a Network Device Definition
panel, but has been superseded by the Incoming/Outgoing Telnet FAD. These devices include:
• TELNET display
• TCP printer
• LPD
IPX SNA Server (Now part of ‘TN3270/IPX SNA Clients’)
This FAD is required if more than 16 IPX SNA Server LUs are configured, but has been
superseded by the TN3270/IPX SNA Clients FAD. Four different FADs are sold:
16, 64, 128 and 256 LU support
These FADs may be used in any combination to allow SAA clients to connect to up to
4048 LUs.