Visara LINCS Central Control - Manual (Page 10)

4
LINCS Central Control
707024-002
Customization Data Source
When you select a Customization Utility (items one through four, i.e. Configuration, KDU,
ADU, or TTU) from the Customization Data Menu, this panel is displayed to allow one to
select the Customization Data Source. The panel title (Configuration in this example) will be
displayed correctly for the customization utility which was entered.
Configuration LINCS C8.2 Central Control
Customization Data Source: Default
PF: 1-Menu 10-Process
Toggle to select the customization data to be read into the working copy. The working copy is
a separate copy of the customization data, which you can modify without affecting the currently
loaded customization.
Options are:
• Default - Start the Configuration with default parameters. Selecting this option will
default the entire working copy as if one had paged through all panels and pressed PF9-
Default on each one.
• Drive A,B,C or D
• Currently Loaded Version - The currently loaded version will be copied to the working
copy. No disk access is needed for this option.
• Working Copy - Display the data object which already exists in the working copy, if
allowed.
The Working Copy option will only be allowed if the following conditions are true:
• Some other session is already viewing or updating the specified data object
• The customization utility was NOT entered in update mode
This option is made available so that if you have two sessions (or two devices next to each
other), you may update a data object in one session, and use the other session to view the
working copy for reference. For example, if you are assigning link profiles on the Gateway
Circuits panel in one session, the other session can be used to view the link profiles which are
currently defined.