Visara LINCS Central Control - Manual (Page 142)

136
LINCS Central Control
707024-002
Link Station Name
This is the name of the circuit.
DLUS Name on APPN Circuit Status
This line shows the name of the DLUS in session with the LINCS DLUR, when it exists. It
also shows the Host Circuit used for that session.
Link Station Address
This is the LAN/SAP address of the adjacent node for LAN Lines.
This is the DLCI for Frame Relay lines.
Port name
This is the name of the port.
Line
This is the line id such as TRC1, ETH1, CHP1 or HSC1.0.
DLC name
This is the name of the DLC.
TG number
This is the number associated with the TG.
Node Type
This is the type of the adjacent node determined during link activation. It is one of the following:
End, Network, LEN (LEN End Node), or VRN (Virtual Routing Node).
Link Station State
This is the state of this link station. This field is set to one of the following: Not Active,
Pending Active, Active, or Pending Inactive.
CP-CP Session Support
This specifies whether CP-CP sessions are supported (YES or No).
SSCP Session Solicited
YES indicates that the circuit has requested the host to initiate an SSCP-PU session for
dependent LUs during the XID negotiation.
Active Sessions
This is the total number of active sessions (both endpoint and intermediate) using this link.
HPR Support
This indicator states whether the node supports High Performance Routing.
Link Level Error Recovery
This indicates whether Link Level Error Recovery is supported or not.
XIDs Received
This is the total number of XID (Exchange IDentification) frames received on this circuit.
XIDs Sent
This is the total number of XID (Exchange IDentification) frames sent on this circuit.