Auto coax recovery, Chapter 9. device options – Visara SCON-20L Configuration Manual User Manual
Page 87
707044-006
9-15
Chapter 9. Device Options
SNA Data Display
This is a toggle field which applies only to SNA sessions on the display and therefore
has no affect on the SCON-2XL.
HAP Session
This field is valid for displays which support the Host Addressable Print (HAP) feature.
It indicates which one of the display’s sessions will be used by the HAP printer which
is attached to the display. By default, the HAP session is the last defined session on the
display. This may be overridden by toggling the field to the desired session.
Note:
The HAP session cannot be session A, it must be sessions B through J.
HAP Status at IML
For devices which support the HAP feature, this field indicates the status of the HAP
session after IML. HAP is not affected by powering the device on and off. By default,
HAP is ENABLED. When HAP is enabled, the HAP session is used for the printer and
will not be available to the display station. If HAP is DISABLED, the HAP session will
be available to the display when the display powers on.
Note:
The HAP session status can be changed using the Display/Update HAP Session
Status on the Device Menu choice of the main Central Control menu.
HAP Profile
For displays which support HAP, this field indicates which printer profile will be used
to define customization parameters for the attached printer.
Note:
The first panel of a Printer Device Profile will be ignored for the HAP printer,
since the Display Device Profile already defined the Host Assignments. The
subsequent panels of the indicated Printer Device Profile will be used to define
characteristics of the HAP session.
This field is required for HAP.
Auto Coax Recovery
When enabled, you can disconnect the coax, and reconnect it, and the device will be
reset as if a power on reset occurred. With this feature disabled, you normally would
have to power the device off then back on, to reestablish communications, once the
coax connection was disconnected.
Resource Authorization Matrix
The Resource Authorization Matrix is used to give devices using this profile access to
LINCS resources. The individual resources are listed under the RESOURCE
DEFINITION column.