Visara SCON-20L Configuration Manual - Manual (Page 119)

707044-006 A-3
Appendix A. RPQs
RPQs Panel #4
RPQs LINCS C8.2 Central Control
DESCRIPTION STATUS
Ignore all LU requests from TN3270 clients Disable
Only Supervisor Displays can enter Test Mode Disable
Maximize TN3287 response timer Disable
Do Not Disc ESCON SNA PU on CU Reset Disable
Delay NSNA LAN print until FF sequence received Disable
(Must configure Disk Buffering)
Don’t optimize outbound data to an ASCII Display Disable
Don’t send Restore Kybd to TN3270 Client for NonSNA end-of-chain Disable
Don’t send Restore Kybd to TN3270 Client for NonSNA Deselect Disable
TN3270 clients MUST specify an LUNAME Disable
Ignore ICMP Redirect Disable
Allow a user to commandeer a 3270 session already in use Disable
Assume all TN3270 clients support extended attributes Disable
Immediately Disconnect NonSNA Client Disable
Send TN3270 connection confirmation to device Disable
Allow alphanumeric input on TN3270 Connect panel Disable
PF: 1-Menu 7-Back 8-Forw 9-Default 10-Done
RPQs Panel #5
RPQs LINCS C8.2 Central Control
DESCRIPTION STATUS
Suppress the automatic CLEAR key when connecting to a Shared Session Disable
During TN3270E negotiation, always tell client what LU was assigned Disable
PF: 1-Menu 7-Back 8-Forw 9-Default 10-Done
Coax Poll Rate (RPQ Panel 2)
This RPQ changes the interval between consecutive polls to a particular port to more closely
match the interval used by the IBM 3174. Enabling this RPQ may be necessary to allow
some DFT devices to work. This RPQ should be enabled to support StorageTek LMUs.
Update Display While Security Keylock is Locked (RPQ Panel 3)
When enabled, if you turn the security keylock into the locked position, the display will
continue to receive screen updates (they will not be displayed). When the keylock is