Visara SCON-20L Configuration Manual - Manual (Page 78)

9-6 707044-006
SCON-20L/22L/25L/28L Configuration Manual
DFT Local Copy Format
The choices in this field allow the enabling or disabling of local copy format controls
that in shared mode (when the printer lacks Save/Restore capability) could interfere
with format controls set up by the host application. Toggle between two options:
• Do NOT Send Format Controls - Choose this option if the host does not reset format
controls with each Begin Bracket (SNA only, does not apply to the SCON-2XL).
• Format Controls Enabled - Choose this option if the host does reset format controls
with each Begin Bracket, or where the printers are not operated in shared mode.
DFT Local Copy Form Feed
The choices in this field allow local copy form feed to occur in one of four modes:
• No Form Feeds
• Form Feed AFTER Local Copy ONLY
• Form Feed BEFORE Local Copy ONLY
• Form Feed BEFORE and AFTER Local Copy
3290 Field Intensity
The choices in this field allow one of three intensity options for use in place of brightness
on DFT/DSL devices that don’t support brightness:
• Underscore
• Reverse Video
• None
3290 Update Panel
The choices in this field are:
• Process host data BEFORE displaying panel – Use this option to maximize
performance. During high data rate transmissions, however, host messages could be
overwritten.
• Display panel BEFORE allowing new host data – Use this option in environments
where 3290s are system consoles and/or all host messages must be seen.
3290 DFT Password
Enter the 6-digit hex password to be used by the DFT devices. For information on 3290
setup conditions requiring the use of the password, refer to the IBM document 3290
Information Panel: Description and Reference, GA23-0021.