Visara SCON-20L Configuration Manual - Manual (Page 13)

707044-006 1-5
Chapter 1. Getting Started
Board Number and Connector Numbering
Since it is possible to support multiple boards of the same type, and it is possible that
there are multiple connectors on some of the boards, the following format was devised
to identify specific connections to the 2XL:
brd#.con where:
brd represents the 3 character board mnemonic described above.
# represents a number 1-9 or letters a-d, identifying the instance of the board that you
are referring to.
A period ( . ) used as a separator.
con representing a three digit number representing the connector number on the board.
Examples:
ESC1 (first ESCON interface card)
MCC1.003 (port 3 on the first MCC board)
Keys for Configuration
The following PF key descriptions apply to most of the Configuration panels. Some
panels have special keys which will be described in the section for that panel.
• PF1 - Menu – This PF key moves configuration processing back to the previous
menu. This key is available on all configuration panels, and may be used to back out.
• PF7 - Back – Pressing PF7 moves you to the previously displayed panel.
• PF8 - Forw – Pressing PF8 moves you to the next panel.
• PF9 - Default – Assign default values to the fields in the current panel.
• PF10 - Done – This signals the end of the configuration process. It will bring you to
the Configuration Complete panel.
• Enter – These keys toggle through available options, when the cursor is on a field
with multiple options.