Visara SCON-20L Configuration Manual - Manual (Page 112)

11-4 707044-006
SCON-20L/22L/25L/28L Configuration Manual
IML Time Panel
IML Time LINCS C8.2 Central Control
Time: HH MM SS Date: MM DD YYYY
1 6 0 3 00 0 3 28 2 0 0 0
PF: 1-Menu 9-Refresh 10-Process
If you select to “IML Later” on the Apply Configuration Changes and process it, the
IML Time panel will appear. On this panel you may enter the time and the date when
you want the SCON-2XL to IML. The time set for IML can be cancelled later if needed
by going into the IML panel under the Supervisor Menu in Central Control Mode.
What to do if Your Configuration Will Not Boot
If you configure optional features, for which you do not have proper licensing support
(through the installation of Feature Activation Disks), the SCON-2XL will not boot up
on the new configuration that you have saved, during the next IML. The most common
causes for this type of problem are:
• Changing the values on the SCON-2XL Product Definition panel
• Configuring too many Host Circuits (more CUs than what you are licensed for)
• Configuring too many Network Devices (Telnet and LAN Printers)
• Configuring too many TN3270 clients
Most error codes caused by misconfiguration will fall into the following error code
ranges:
• 9Fx
• B5x
• B6x
• B7x
A procedure to correct the problem is as follows.
Press the IML button on the front panel, to initiate a fresh IML. When the unit reaches
IML state 500, a pause of about 5-10 seconds will occur. During this pause press the
button on the front panel. This will cause the 2XL to boot on the factory