Visara SCON-20L Configuration Manual - Manual (Page 113)

707044-006 11-5
Chapter 11. Configuration Complete
default configuration, based on the actual hardware installed in the unit. You should see
the Configuration indicator on the front panel light when the IML continues beyond
state 500, and remain on until the IML is complete. When fully booted, the SCON-2XL
will display the word ‘CONFIGURATION’ on the front panel LCD.
From a coax terminal (or other suitable display device), go into Central Control Mode
and into the customization utility. You have a couple of choices as you enter the utility.
If you select to use the “Default” data source, you can configure the 2XL from scratch,
the same as when you first received it. You can also select “Drive C” as the source,
which will bring up the last saved configuration (the one with the problem) and allow
you to attempt to change the configuration to one that will work.