Visara SCON-20L Configuration Manual - Manual (Page 36)

3-10 707044-006
SCON-20L/22L/25L/28L Configuration Manual
LPD Server/Printers Drive
This field allows you to toggle through the choices of none and all of the hard drives that
are installed, to indicate whether you wish to assign a hard drive as a location to temporarily
store LPD print jobs when LINCS is configured as a LPD Print Server or when supporting
LPD LAN printers. If a hard drive is not defined, then memory will be used instead. To
conserve on memory a hard disk setting is recommended. When enabling a hard disk
setting it is recommended to also enable the RPQ: ‘make hard disk priority higher’.
SNMP System Location
This 64-character field can be used to describe the physical location of the LINCS
node. Valid characters are: alphanumeric, space, dollar, period, hyphen, and underscore.
This information is returned as part of the LINCS MIB.
SNMP System Contact
This 48-character field can be used to define the name of the individual who is the contact
person for this LINCS node. Valid characters are: alphanumeric, space, dollar, period,
hyphen, and underscore. This information is returned as part of the LINCS MIB.
SNMP System Name
This 48-character field can be used to define the administratively-assigned name for
this managed LINCS node. By convention, the System Name is the fully qualified domain
name. Valid characters are: alphanumeric, space, dollar, period, hyphen, and underscore.
This information is returned as part of the LINCS MIB.
TN3270E
Enable this option if TN3270E clients are to be used. You must enable this to support
1783 and 1883 NCT clients as consoles using TN3270E. It is recommended that this
option is enabled unless you are using only standard TN3270 clients that do not support
the connection to a TN3270 Server that supports TN3270E negotiation.
ATTN and SYSREQ
These options apply to TN3270 clients only (not TN3270E). Configuring these options
require that the corresponding options on the TN3270 clients be configured to use the
same TELNET commands.
3270 Translate
This option may be used to allow the 2XL to provide local to remote datastream
translation for TN3270 (not TN3270E) clients incapable of supporting local channel
3270 orders.