Visara SCON-20L Configuration Manual - Manual (Page 30)

3-4 707044-006
SCON-20L/22L/25L/28L Configuration Manual
Each of the 32 sessions that can be associated with a single CU definition, can be
configured to be hot. Hot sessions are identified as such, by changing the value from ‘0’
in the appropriate column.
Definitions for the values to enter are:
0 = Not defined to be a hot session
1 = Hot Session (Mod 2 with Extended Data Stream Support)
2 = Hot Session (Mod 2 with Extended Data Stream Support)
3 = Hot Session (Mod 3 with Extended Data Stream Support)
4 = Hot Session (Mod 4 with Extended Data Stream Support)
5 = Hot Session (Mod 5 with Extended Data Stream Support)
6 = Hot Session (Mod 2 with No Extended Data Stream Support)
7 = Hot Session (Mod 3 with No Extended Data Stream Support)
8 = Hot Session (Mod 4 with No Extended Data Steam Support)
9 = Hot Session (Mod 2 with Extended Data Stream Support)
The leftmost column corresponds to the Device Low address, defined above. All device
addressing on subsequent panels are referenced from this offset of ‘00’.
Note that only the console sessions should be configured as hot (not the normal
VTAM sessions).
Shared Sessions
Shared Sessions allows two or more TN3270 clients to share the same console session.
Up to twenty-four TN3270 users can be configured to share the same session. Coax and
Telnet clients are not allowed to share the session. Only console sessions can be shared.
VTAM applications will not function correctly when configured as shared. All TN3270
clients sharing the same session should be configured for the same MOD size and
should have the same Color and Extended Attribute support (the first user to connect
sets the standard for the session). To designate a session to be shared, change the 0
value to a 1 for that session.
Line Options/FET Panel
Line Options/FET1 LINCS C8.2 Central Control
LAN Address: 0200 2201 1010
Media Type: Auto Negotiate
Duplex Mode: Auto
TCP/IP: Enable
Coax Ethernet Bridge: Enable
PF: 1-Menu 7-Back 8-Forw 9-Default 10-Done