Visara SCON-20L Configuration Manual - Manual (Page 53)

707044-006 5-11
Chapter 5. Telnet Host Sessions
Class
This field shows class numbers. A class is a unique group of one or more IP hosts and
the devices that have access to these hosts. There can be up to 16 classes; the numbers
are 1 through 16 and are predefined.
Line to IP Host
Enter the line which will be used to connect to the IP Host(s) in this IP Host Class.
IP Address or Name
Enter a four-octet decimal number for the IP address of the remote IP Host or enter the
Domain Name of the remote IP host. The IP address should be a uniquely assigned
value given to the remote device by the network administrator. It needs to follow the
guidelines of any IP address assignment, four octets separated by dots. If a Domain
Name is used, you should have previously configured an address for the DNS Server in
order for LINCS to get the Domain Name resolved.
ASCII Session Profile
This is the number of the ASCII Session Profile created in the previous panel/step. The
range is from 0 to 15.
Class Name
This field, which lets you specify a name for the class, must be filled in if any IP hosts
are defined. The name could indicate the IP host to which the ports in that class are
connected or could identify the host application that is accessible via the host ports.
Since there can be up to 16 classes, each class name must be unique. Class names
cannot exceed 16 alphanumeric characters (including hyphen, period and underscore),
and are required.
After configuration, this class name is used on the IP Host Connection panel.