Visara SCON-20L Configuration Manual - Manual (Page 109)

707044-006 11-1
Chapter 11. Configuration Complete
When configuring in Central Control mode, pressing PF10-Save on the Configuration
Complete panel causes all Configuration data to be examined for inconsistencies. If
any inconsistencies are present, a message will be displayed to direct you to the panel
containing the error. Upon paging to the panel in error, the specific warning message
will be displayed. Configuration data may NOT be saved as long as any inconsistencies
exist.
When configuring with the Central Site Facility, PF3-Return will be displayed instead
of PF10-Save. PF3-Return returns you to the Central Site Library panel, so you can
save or do whatever you like with the Working Copy just modified.
Once the Configuration Data has been validated and saved, the Apply Configuration
Changes panel will be displayed.
Configuration Complete Panel
Configuration Complete LINCS C8.2 Central Control
System Disk Drive: Drive C
Feature Activation is Required for: (*=not active on this 1174)
HPP’s Required: 0
If an extra HPP is available, it will be used for the Network Devices.
PF: 1-Menu 7-Back 9-Default 10-Save
The Configuration Complete panel displays Feature Activation and HPP requirements
based upon the values in the Configuration Data.
Once the Configuration Data has been validated and saved, the Apply Configuration
Changes panel will be displayed.
System Disk Drive
This is a toggle field which indicates which disk to write the Configuration data to. The
initial value will be the drive which the data was read from. The field may be toggled to
any drive which contains a System disk. You must save the configuration to drive C, to
use the new configuration for subsequent IML’s.
HPP Requirements
The SCON-2XL products do not make use of the HPP card, used by other members of
the Visara Communication Server product family. Any configuration that specifies a
requirement for a HPP on the SCON-20L or SCON-22L is an invalid configuration for
this product.