Visara SCON-20L Configuration Manual - Manual (Page 86)

9-14 707044-006
SCON-20L/22L/25L/28L Configuration Manual
Session Auto Swap
When enabled, this feature will automatically swap the user to their next configured
session, if a comm reminder appears in their status line, indicating that their host
connection has gone down. For example, if the user has two sessions A and B, and they
are working in session A, but the host connection goes down, they will automatically
be swapped to their session B.
Keyboard Tables
Toggle to select:
• Host Language (default) - Sets the keyboard table language to the language of the
host that the session is connected to. The host language is configured in the 3270
Host Profile and/or ASCII Session Profile, depending upon the type of host session.
The language will be set to the host language upon POR of the device, when
connecting to a host, and when swapping sessions. If a session is not connected to a
host upon POR, the keyboard tables language will be set to the primary language
until the session connects.
• Primary - The keyboard table language will be set to the primary language upon
POR of the device.
• Secondary - The keyboard table language will be set to the secondary language
upon POR of the device.
Connecting to a 3270 host does NOT affect the keyboard language when Primary or
Secondary is chosen.
Note: When connecting to an ASCII host, the keyboard table language and host
translate table language will ALWAYS be the same. Both languages will be
set to the language specified in the ASCII Session profile. When pressing
Exsel-L to toggle the keyboard language, both languages will be set to the
alternate language.
PC File Transfer
Options are: ENABLE or DISABLE
This configuration option determines the status of File Transfer after IML. If an attached
device is powered off and on, File Transfer is not affected.
PC File Transfer and Windowing cannot be used concurrently. For this reason, a hot
key is available (Alt X) to allow for quick entry or exit to File Transfer mode. If you
wish to use Windowing on a PC configured for file transfer, you must disable File
Transfer by pressing this key sequence prior to selecting a windowing profile other than
profile 0. To perform a File Transfer operation, you must go back to profile 0 and re-
enable File Transfer by pressing the key again.
Note: Due to the extra coax processing required, performance degradation occurs if
you’ve enabled PC File Transfer on ports that will not be performing file
transfers, for example, CUT devices, printers, and DFTs. You must enable file
transfer for display profiles assigned to StorageTek LMUs.