Visara SCON-20L Configuration Manual - Manual (Page 32)

3-6 707044-006
SCON-20L/22L/25L/28L Configuration Manual
Line Options, TCP/IP Options Panel
Line Options/FET1 LINCS C8.2 Central Control
TCP/IP OPTIONS
IP Address: 195 195 195 001
Subnet Mask: 255 255 255 000
TELNET Host Connections: 000
TN3270 Client Connections: 0000
IP Router: Disable
BSD 4.2 IP Broadcast: Disable
Expanded IP Addressing: Disable
TCP Quiet Time (sec): 0000
Default Router Address: ___ ___ ___ ___
DNS Primary Name Server: ___ ___ ___ ___
DNS Secondary Name Server: ___ ___ ___ ___
DNS/Ping Response Time: 0000
DNS Default Domain:
___________________________________________________________________
SNMP Trap IP Address: ___ ___ ___ ___
SNMP Read Authentication String: ________________
SNMP Write Authentication String: ________________
PF: 1-Menu 7-Back 8-Forw 9-Default 10-Done
When TCP/IP is selected as a protocol for the FET (Ethernet) board, the Line Options,
TCP/IP Options panel will appear. The minimum configuration for this panel requires
that you fill in an IP address. In most cases however, you will also need to fill in the
Default Router address, and you may also want to fill in the Subnet Mask field. Below
you will find descriptions for all of the options on this panel.
IP Address
This is the IP address for the line. It should follow the rules for IP addresses, which
your system administrator can give you. If this address is connected to the Internet as
controlled by the NIC, bear in mind that users can connect to LINCS by the IP address
you give it. Design your host's connection to the Internet with this in mind.
Subnet Mask
This is the subnet mask that LINCS will use for the IP address entered. If no subnet
mask is entered, but a default router is defined, LINCS will automatically attempt to
obtain the subnet mask from the router. If no subnet mask and no default router are
defined, LINCS will assume the default subnet mask based on the class of the IP address
being used.