Dixon Aficio 1515 - Manual (Page 277)

System Settings (Parallel Connection)
39
4
System Settings (Parallel Connection)
Interface Settings/Parallel Interface
❖ ❖ ❖ ❖ Parallel Timing
Specifies the timing for the parallel
interface. Normally, you do not
need to change this setting.
• ACK inside
• ACK outside
• STB down
Note
❒ Default: ACK outside
❖ ❖ ❖ ❖ Parallel Comm. Speed
Specifies the communication
speed of the parallel interface. If
the speed is too high, data may not
be transferred smoothly. If this
happens, change the setting to
“Standard”.
• High Speed
• Standard
Note
❒ Default: High Speed
❖ ❖ ❖ ❖ Selection Signal Status
Specifies the signal level of the par-
allel interface.
• High
• Low
Note
❒ Default: High
❖ ❖ ❖ ❖ Input Prime
Specifies whether the prime signal
is active or inactive when an input
prime signal is sent. Normally, you
do not need to change this setting.
• Effective
• Invalid
Note
❒ Default: Invalid
❖ ❖ ❖ ❖ Bidirectional Comm.
Specifies, for instance, how a print-
er connected to the parallel inter-
face responds to a status request. If
you experience problems using an-
other manufacturer’s printer, set
this to Off.
Limitation
❒ If set to Off, asynchronous com-
munication will not work.
• On
• Off
Note
❒ Default: On
❖ ❖ ❖ ❖ Signal Control
Specifies how to handle any errors
that occur when printing from a
computer or sending faxes. Nor-
mally, you do not need to change
this setting.
• Job Acceptance Priority
• Printer Priority
Note
❒ Default: Job Acceptance Priority