Gasboy Fuel Point PLUS Vehicle - Manual (Page 99)

Fuel Point PLUS Vehicle Installation and Configuration Manual 99
4-6.
FR AND DP PROGRAMMING SEQUENCE FOR LIGHT VEHICLES
Table 4-13 describes the programming sequence for light vehicles equipped with Fuel Ring
only and Fuel Ring and DataPass light devices.
Table 4-14 describes the sequence for units connected directly to odometer pulses output.
Verify that DP is already installed and the DP is powered (turn ignition switch ON)
Turn on the WP; follow the instructions appearing on the WP display, described in the tables
below.
Table 4-13. FR and DP Light Programming Sequence
Step Display Description/Action
1 Enter User ID
Enter password
2 Place the WP coil near the vehicle's fuel inlet
3 Wait a few seconds until the WP recognizes the
Fuel Ring
4 The Organization Name is displayed
If the WP is associated to several HO, select the
required organization
5 1. Enter Vehicle ID (8 characters)
2. Reenter Vehicle ID for confirmation
6 Enter fleet code (4 characters)
7 Enter the allowed fuel type code
8 FR type options are displayed:
Enter 1 to program a Fuel Ring device only.