Gasboy Fuel Point PLUS Vehicle - Manual (Page 101)

Fuel Point PLUS Vehicle Installation and Configuration Manual 101
Step Display Description/Action
16
Select additional vehicle data, if any
17 The detected DP type is displayed
18 Select the communication protocol
19 Select the DP connection type (whether DP is
connected to ignition switch or not) to set the unit
sleep mode.
If working with Odometer pulses, proceed to
Step 20 in Table 4-14
20 Odometer reading option. Default: Y
Press ENTER to collect odometer reading
Change default to N to disable the option
21 Distance measurement units' definition:
Enter 1 for Km.
Enter 2 for Miles
If Odometer reading was disabled, proceed to
Step 24
22 DP Factor is displayed. Edit the parameter,
entering a known factor, if needed
23 DP Offset is displayed. Edit the parameter,
entering a known offset, if needed
24 E.H. reading option. Default: Y
Press ENTER to collect E.H. reading
Change default to N to disable the option
25 This screen is displayed only in cases where
Odometer reading was not disabled.
Edit the parameter, entering the value displayed