Gasboy Fuel Point PLUS Vehicle - Manual (Page 52)

Fuel Point PLUS Vehicle Installation and Configuration Manual 52
Figure 3-15. Covering Unconnected Wires with Insulating Tape
6. Wrap the newly created harness in insulating tape
7. Connect the DataPass to the harness
8. Fasten the DataPass to any of the vehicle panels/rods using a tie wrap; verify that the
unit does not move (see Figure 3-16)
Figure 3-16. Fastening the DataPass Unit
9. Fasten the newly created harness to any of the vehicle panel/rod; verify that the harness
is well secured
10. Re-assemble the Diagnostics connector panel.
3-5.3.1. Adaptor Plug
As previously mentioned, the Adaptor plug is used only in cases where it is difficult to access the
connector's rear side .
Perform the following steps:
3. Connect the red connector of the adaptor plug to the car's Diagnostics connector (see
Figure 3-17)