Gasboy Fuel Point PLUS Vehicle User Manual
Page 47
Fuel Point PLUS Vehicle Installation and Configuration Manual
47
Parameter
Value
Data rate: 10400bps
3-3.2.
µDataPass Pinout
Table 3-7 details the µDataPass connector pinout:
Table 3-7. µDataPass Pinout
Pin #
Pin Name
Description
16
VIN+
Supplied voltage (+)
4
VIN-
Supplied voltage (-)
7
K-line (ISO) Utilized for K- line protocol
6
CAN H
For CanBus protocol, connect to 'CAN
H' in the vehicle bus
14
CAN L
For CanBus protocol, connect to 'CAN
L' in the vehicle bus
3-4.
TOOLS REQUIRED FOR INSTALLATION
The following tools may be needed for installing the DataPass and μDataPass units:
Star head Screwdriver (TORX)
Flat head Screwdriver
Philips head screwdriver
Cutter
Isolating tape
Soldering iron
Soldering tin
3-5.
LIGHT VEHICLES INSTALLATION
3-5.1.
Checking Vehicle Protocol
In order to install and use the appropriate µDataPass/DataPass unit, it is necessary to check out the
bus protocol: K-Line or Can bus. The Vehicle Call Monitor unit – VCM (see Figure 3-6) enables
users to find out which OBD-II protocol is supported by the vehicle, for cases where the
manufacturer specifications are not available.