Gasboy Fuel Point PLUS Vehicle - Manual (Page 8)

Fuel Point PLUS Vehicle Installation and Configuration Manual VIII
LIST OF ILLUSTRATIONS
Figure Page
Figure 1-1. Fuel Point PLUS System Architecture 14
Figure 2-1. Fuel Ring Components 16
Figure 2-2. Light Vehicle Typical Installation Kit Components 18
Figure 2-3. Heavy Vehicle Kit Description 19
Figure 2-4. Fuel Ring Shaped Coil 20
Figure 2-5. Fuel Ring Self Installed Coil 21
Figure 2-6. Fuel Ring Molded Coil 22
Figure 2-7. Typical Installation Approved Location 24
Figure 2-8. ID Chip Preferred Position 25
Figure 2-9. Inserting One-Way Screw 26
Figure 2-10. Applying Adhesive 26
Figure 2-11. Securing the Clamps 27
Figure 2-12. Securing the ID Chip 28
Figure 2-13. Drilling the Trunk 28
Figure 2-14. Securing the ID Chip 29
Figure 2-15. CV Joint Banding Tool and Cutter 31
Figure 2-16. Positioning the Clamps 32
Figure 2-17. Tightening the Clamps 33
Figure 2-18. Complete Coil Installation on Long Neck Inlet 33
Figure 2-19. Securing Clamps on Short Neck Inlet 34
Figure 2-20. Complete Coil Installation on Short Neck Inlet 35
Figure 2-21. Complete Coil Self – Installation 35
Figure 2-22. ID Chip Installed in a Security Cover 36
Figure 2-23. Attaching the Security Cover to a Bar 36
Figure 2-24. Tightening Security Cover 37
Figure 3-1. DataPass for Light Vehicles (OBD-II) 41
Figure 3-2. DataPass (J1708/FMS) for Heavy Vehicles 41
Figure 3-3. DataPass Harness 42
Figure 3-4. µDataPass for CAN Bus 45
Figure 3-5. µDataPass for K-Line Bus 45
Figure 3-6. VCM Unit 48
Figure 3-7. Diagnostics Connector 48
Figure 3-8. Pluging the μDataPass 49
Figure 3-9. Tightening the μDataPass 49
Figure 3-10.OBDII Connector Wiring to DataPass Harness 50
Figure 3-11. OBDII Connector Pins Layout 50