Gasboy Fuel Point PLUS Vehicle - Manual (Page 100)

Fuel Point PLUS Vehicle Installation and Configuration Manual 100
Step Display Description/Action
In this case proceed to step 27
Enter 2 to program both Fuel Ring and
DataPass devices
9
DP MAC address (unique unit ID) insertion:
Enter 1 to automatically recognize DP MAC
address. Stay inside the vehicle close to DP, or
at a maximum range of ~0.5m to maintain
proper receiving signal and avoid the
possibility of finding by mistake another DP.
Wait up to seven seconds for result
Enter 2 for manual insertion of the MAC
address
Verify the automatically entered MAC/Type the
eight characters as shown on DP rear label and
save
10
Wait a few seconds until the WP recognizes the
DP.
Continue to Step 13, except for the following:
11 In cases where the current DP version is old,
users may update DP firmware:
Press Y to update
Press N to continue the current process
12
In cases where the DP has been previously
programmed, approve re-programming: press Y
13
Select the vehicle manufacturer
14
Select the vehicle model
15
Select the vehicle year