Gasboy Fuel Point PLUS Vehicle - Manual (Page 105)

Fuel Point PLUS Vehicle Installation and Configuration Manual 105
4-7.
FR AND µDP PROGRAMMING SEQUENCE
Table 4-15 describes the programming sequence for vehicles equipped with Fuel Ring only and
Fuel Ring and μDataPass/ μDataPass Plus devices.
Verify that μDP is already installed and the μDP is powered (turn ignition switch ON)
Turn on the WP; follow the instructions appearing on the WP display, described in the tables
below.
Table 4-15. FR and μDP Programming Sequence
Step Display Description/Action
1 Enter User ID
Enter password
2 Place the WP coil near the vehicle's fuel inlet
3 Wait a few seconds until the WP recognizes the
Fuel Ring
4 The Organization Name is displayed
If the WP is associated to several HO, select the
required organization
5 1. Enter Vehicle ID (8 characters)
2. Reenter Vehicle ID for confirmation
6 Enter fleet code (4 characters)
7 Enter the allowed fuel type code
8 FR type options are displayed:
Enter 1 to program a Fuel Ring device only.
In this case proceed to step 37