Gasboy Fuel Point PLUS Vehicle - Manual (Page 113)

Fuel Point PLUS Vehicle Installation and Configuration Manual 113
4-9.
ADDING FP TO DP ONLY
Add DP to FP option enables the technician to add a Fuel Ring to a vehicle equipped with DP only.
Table 4-17 describes the Add FP to DP sequence steps common to all DP types.
Verify that the DP is powered (turn ignition switch ON).
Turn on the WP; follow the instructions appearing on the WP display, described below.
Table 4-17. Add FP to DP Sequence
Step Display Description/Action
1 Enter user ID
Enter password
2 The WP Functions menu is displayed. Use the
DOWN arrow key to move the pointer (>) to the
Add FP to DP option
3 Wait a few seconds until the WP recognizes the
Fuel Ring
4 DP MAC address (unique unit ID) insertion:
Enter 1 to automatically recognize DP MAC
address. Stay inside the vehicle close to DP,
or at a maximum range of ~0.5m to maintain
proper receiving signal and avoid the
possibility of finding by mistake another DP.
Wait up to seven seconds for result
Enter 2 for manual insertion of the MAC
address
5 Verify the automatically entered MAC/Type the
eight characters as shown on DP rear label and
save.
In cases where automatic recognition was
selected and more than one DP is detected,
the WP shows the MAC addresses of all DP