Gasboy Fuel Point PLUS Vehicle - Manual (Page 39)

Fuel Point PLUS Vehicle Installation and Configuration Manual 39
The DataPass Plus and µDataPass Plus vehicle units collect on top of Odometer and Engine Hour,
additional information from the vehicle, enabling the Fleet Managers to get an updated picture on
the vehicles' current status. Table 3-2 describes all vehicle parameters which may be collected and
reported by DataPass Plus devices.
Table 3-2. DataPass Plus Vehicle Parameters
Parameter Description
Odometer The odometer reading from the vehicle
Main Engine Hour Number of engine hours of the vehicle's main engine
Error Codes On-Board Diagnostics error codes
Aux#1 E.H. Engine Hours of the utility engine which may be
connected to vehicle bus or to DataPass physical line
#1
Aux#2 E.H. Engine Hours of the utility engine which may be
connected to vehicle bus or to DataPass physical line
#2
PTO Power take-off operating hours
Idle Time Idle time counter starts whenever the vehicle's engine is
running while the speed is zero for a period longer than
the threshold defined for the vehicle. Number of events
and accumulated idle time are both provided
Over Speeding Accumulated time that the vehicle was driven over the
speed threshold set for the vehicle
Over RPM Number of events in which the vehicle crossed the set
RPM threshold
Fuel Level Fuel volume reading at the time of data downloading
(when vehicle enters the WGT network)
Fuel Consumed Total amount of fuel the vehicle consumed (from day
one)
3-1.2.
Availability of Vehicle Data according to Vehicle Interface Type
Table 3-3 enumerates the list of data parameters that can be supported by each of the vehicle
interface types. The various DataPass types can provide parameters according to their availability in
the various interfaces.
Table 3-3. Availability of Vehicle Data according to DataPass and Interface Type
DP+ Heavy μDP+ μDP+ DP Heavy μDP μDP