Gasboy Fuel Point PLUS Vehicle - Manual (Page 27)

Fuel Point PLUS Vehicle Installation and Configuration Manual 27
8. To secure the coil using clamps:
a. Place two clamps on the coil
b. Place the coil so that the coil support legs face the metal surface and the cable
extending from the coil faces the ID chip
c. Using two self-drilled screws, secure the clamps (see Figure 2-11). Be very
careful not to drill through the fuel tank.
Figure 2-11. Securing the Clamps
To secure the coil using glue:
a. Clean the surface to be glued
b. Apply few drops of Cyanoacrylate adhesive (SuperGlue) to the bottom of the
coil's support legs surface
c. Place the coil so that the coil support legs face the metal surface and the cable
extending from the coil faces the ID chip and hold for several seconds
d. While securing the coil, spray instant glue accelerator around the area.
9. To secure the unit against theft, apply Acrylic, dual-components (epoxy glue) to the
upper and lower part of the chip only as shown in Figure 2-12