Gasboy Fuel Point PLUS Vehicle - Manual (Page 48)

Fuel Point PLUS Vehicle Installation and Configuration Manual 48
Proceed as follows:
1. Connect the VCN unit to the OBD-II connector using a DataPass harness (P/N
M09680B051)
2. The appropriated indicator LED is lit (K-Line or CAN)
Figure 3-6. VCM Unit
3-5.2.
Installing the μDataPass
The µDataPass installation is a very simple process. However, since µDataPass is a very small
device, it is recommended to fasten the unit to the vehicle using a nylon thread or similar fastener to
prevent loss if removed from the OBD II connector during vehicle servicing.
Proceed as follows:
1. Locate the standard On Board Diagnostics (OBD II, see Figure 3-7) connector (usually
hidden behind one of the panels below the steering wheel, or near the pedals)
2. Remove the panel covering the Diagnostics connector
Figure 3-7. Diagnostics Connector
3. Gently plug the µDataPass into the Diagnostics connector being careful not to bend the
µDataPass pins (see Figure 3-8)