Gasboy Fuel Point PLUS Vehicle - Manual (Page 89)

Fuel Point PLUS Vehicle Installation and Configuration Manual 89
Step Display Description/Action
21 Odometer Address (Default: 255) and DP
Odometer Address (Default: 141). Save or edit
the parameters and save
22 Distance measurement units' definition: 1 for
Km. or 2 for Miles. Default: Miles. Save or edit
the parameter and save
23 E.H. reading option. Default: Y
Press ENTER to collect E.H. reading
Change default to N to disable the option.
In this case, proceed to Step 27
24 Select the input source for Engine Hour reading:
1 for Switch or 2 for Vehicle Bus. Default: Bus
Press ENTER to select Bus
Change default to 1 to select Switch. In
this case, proceed to Step 27
25 E.H. Address (Default: 255) and DP E.H.
Address (Default: 141). Save or edit the
parameters and save
26 The E.H. PID (Parameter ID) is displayed.
Default: 247. Save or edit the parameter
(changing the value to 246) and save
27 Switch on the engine, wait 20 seconds and then
press SEND. DP attempts to read the
odometer/engine hours
28 Odometer reading is displayed. Edit the
parameter, entering the value displayed on the
dashboard
29 Engine Hour reading is displayed, in cases where
the E.H. source is the Bus. Otherwise, a zero is
displayed.
Edit the parameter, entering the value displayed
on the dashboard (if available)