Gasboy Fuel Point PLUS Vehicle User Manual

Page 87

Fuel Point PLUS Vehicle Installation and Configuration Manual

Step

Display

Description/Action

In this case proceed to Step 54

Enter 2 to program both Fuel Ring and

DataPass devices

DP MAC address (unique unit ID) insertion:

Enter 1 to automatically recognize DP MAC

address. Stay inside the vehicle close to DP, or

at a maximum range of ~0.5m to maintain

proper receiving signal and avoid the

possibility of finding by mistake another DP.

Wait up to seven seconds for result

Enter 2 for manual insertion of the MAC

address

Verify the automatically entered MAC/Type the

eight characters as shown on DP rear label and

save

Wait a few seconds until the WP recognizes the

DP.

Continue to Step 13, except for the following:

In cases where the current DP version is old,

users may update DP firmware (i.e. update DP to

DP+):

Press Y to update

Press N to continue the current process

In cases where the DP has been previously

programmed, approve re-programming: press Y

The following options are available when

using WP ARM ver. 2.1.16, AVR ver. 4.3.6

and up, DP ver. 4.2 and up:

Select Add FP to correlate an additional Fuel

Ring to the DP (for multi-tank trucks) and

proceed to Step 54

Select Overwrite to re-program the DP and

continue to Step 13

Select to replace a defective FP in cases where